How To Configure A Virtual Server; Figure 125 Creating The Address Object For The Wan2 Public Ip Address; Figure 126 Creating The Virtual Server - ZyXEL Communications 200 Series User Manual

Chapter 6 Tutorials

Figure 125 Creating the Address Object for the wan2 Public IP Address

6.10.2 How to Configure a Virtual Server

You need a virtual server to send HTTP traffic coming to IP address 1.1.1.2 on wan2 to the
HTTP server's private IP address of 192.168.3.7. In the Network > Virtual Server screen,
click the + symbol and create a new virtual server entry as shown next.
• This virtual server is for traffic coming in on wan2 to IP address 1.1.1.2 (defined in the
WAN2_HTTP object).
• The virtual server sends this traffic to the HTTP server's private IP address of 192.168.3.7
(defined in the DMZ_HTTP object).
• HTTP traffic and the HTTP server in this example both use TCP port 80. So you set the
Port Mapping Type to Port, the Protocol Type to TCP, and the original and mapped
ports to 80.
• In this example 1.1.1.2 is not the default IP address for sessions going out through wan2.
Select Add corresponding Policy Route rule for NAT 1:1 mapping to send the HTTP
server's outgoing sessions through wan2 and use 1.1.1.2 as the source IP address (to
match the IP address for accessing it). See
• Select Add corresponding Policy Route rule for NAT Loopback to allow local users to
use a domain name to access the HTTP server. See
for details.

Figure 126 Creating the Virtual Server

168
NAT 1:1 Example on page 313
NAT Loopback Example on page 317
ZyWALL USG 100/200 Series User's Guide
for details.