Table 64 Interface > Cellular > Status - ZyXEL Communications 200 Series User Manual

Chapter 10 Interface
The following table describes the labels in this screen.
Table 64 Interface > Cellular > Status
LABEL
Refresh
#
Extension Slot
Connected Device
Status
Service Provider
Cellular System
232
DESCRIPTION
Click this button to update the information in the screen.
This field is a sequential value, and it is not associated with any interface.
This field displays where the entry's cellular card is located.
This field displays the model name of the cellular card.
No device - no 3G device is connected to the ZyWALL.
Device detected - displays when you connect a 3G device.
Device error - a 3G device is connected but there is an error.
Probe device fail - the ZyWALL's test of the 3G device failed.
Probe device ok - the ZyWALL's test of the 3G device failed.
Init device fail - the ZyWALL was not able to initialize the 3G device.
Init device ok - the ZyWALL initialized the 3G card.
Check lock fail - the ZyWALL's check of whether or not the 3G device is locked
failed.
Device locked - the 3G device is locked.
SIM error - there is a SIM card error on the 3G device.
SIM locked-PUK - the PUK is locked on the 3G device's SIM card.
SIM locked-PIN - the PIN is locked on the 3G device's SIM card.
Unlock PUK fail - Your attempt to unlock a WCDMA 3G device's PUK failed
because you entered an incorrect PUK.
Unlock PIN fail - Your attempt to unlock a WCDMA 3G device's PIN failed
because you entered an incorrect PIN.
Unlock device fail - Your attempt to unlock a CDMA2000 3G device failed
because you entered an incorrect device code.
Device unlocked - You entered the correct device code and unlocked a
CDMA2000 3G device.
Get dev-info fail - The ZyWALL cannot get cellular device information.
Get dev-info ok - The ZyWALL succeeded in retrieving 3G device information.
Searching network - The 3G device is searching for a network.
Get signal fail - The 3G device cannot get a signal from a network.
Network found - The 3G device found a network.
Apply config - The ZyWALL is applying your configuration to the 3G device.
Inactive - The 3G interface is disabled.
Active - The 3G interface is enabled.
Incorrect device - The connected 3G device is not compatible with the ZyWALL.
Correct device - The ZyWALL detected a compatible 3G device.
Set band fail - Applying your band selection was not successful.
Set band ok - The ZyWALL successfully applied your band selection.
Set profile fail - Applying your ISP settings was not successful.
Set profile ok - The ZyWALL successfully applied your ISP settings.
PPP fail - The ZyWALL failed to create a PPP connection for the cellular interface.
Device ready - The ZyWALL successfully applied all of your configuration and you
can use the 3G connection.
This displays the name of your network service provider or Limited Service when
the signal strength is too low.
This field displays what type of cellular network the 3G connection is using. The
network type varies depending on the 3G card you inserted and could be UMTS,
UMTS/HSDPA, GPRS or EDGE when you insert a GSM 3G card, or 1xRTT,
EVDO Rev.0 or EVDO Rev.A when you insert a CDMA 3G card.
ZyWALL USG 100/200 Series User's Guide