Ip Static Route Setup; Figure 21-3 Menu 11.5 Remote Node Filter (Ethernet Encapsulation ); Figure 21-4 Menu 11.5 Remote Node Filter (Pptp Or Pppoe Encapsulation) - ZyXEL Communications ZyAIR User Manual

Figure 21-3 Menu 11.5 Remote Node Filter (Ethernet Encapsulation )

Figure 21-4 Menu 11.5 Remote Node Filter (PPTP or PPPoE Encapsulation)

21.2.1 IP Static Route Setup

Static routes tell the ZyAIR routing information that it cannot learn automatically through other means. This
can arise in cases where RIP is disabled on the LAN or a remote network is beyond the one that is directly
connected to a remote node.
Each remote node specifies only the network to which the gateway is directly connected and the ZyAIR has
no knowledge of the networks beyond. For instance, the ZyAIR knows about network N2 in the following
figure through remote node Router 1. However, the ZyAIR is unable to route a packet to network N3
because it does not know that there is a route through remote node Router 1 (via Router 2). The static routes
allow you to tell the ZyAIR about the networks beyond the remote nodes.
Remote Node Configuration
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters= 1, 2, 3
device filters=
Output Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters= 1
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
ZyAIR Wireless Gateway Series User's Guide
21-7