Table of Contents
Advertisement
21.6.2 Add/Edit VRPT Management
Use this screen to configure a VRPT server. To open this screen, click Add or Edit in the
CNM System Setting > Configuration > VRPT Management screen.
Figure 176 CNM System Setting > Configuration > VRPT Management > Add/Edit
The following table describes the labels in this screen.
Table 151 CNM System Setting > Configuration > VRPT Management > Add/Edit
LABEL
Name
Syslog Server Address
Description
Add Devices to VRPT Server Click the
Apply
Cancel
Vantage CNM User's Guide
DESCRIPTION
Enter a descriptive name of the Vantage Report instance in Vantage
CNM. You must use 3-28 alphanumeric characters, underscores (_),
dashes (-), or periods (.).
Enter the IP address of the Vantage Report server.
Type a description, if desired, for the Vantage Report instance. You can
use up to 255 printable ASCII characters.
icon and the associated devices screen appears where
you can select associated device(s) to this VRPT server. Click Add to
return to the previous screen and the selected device(s) display in the
Associated Devices field. When you click Apply, Vantage CNM
automatically configures these devices to send log messages to this
Vantage Report. It does not change any settings for log categories or
traffic statistics, so you might have to change these manually. See
Table 225 on page
414.
To unassociate a device to the VRPT server, click the
unselect the associated device from the list. Then click Add. When you
click Apply, Vantage CNM automatically resets the syslog settings to
their default values for devices that previously used the specified
Vantage Report server. It does not change any settings for log
categories or traffic statistics.
Click Apply to save these changes.
Click Cancel to return to the previous screen without saving changes.
Chapter 21 CNM System Setting
icon and
307
Advertisement
Table of Contents
Troubleshooting
