Trigger Port; Figure 90 Device Operation > Device Configuration > Advanced > Nat > Trigger Port - ZyXEL Communications Centralized Network Management Vantage CNM User Manual

Table 79 Device Operation > Device Configuration > Advanced > NAT > Address Mapping >
Edit (continued)
LABEL
Local End IP
Global Start IP
Global End IP
Apply
Cancel

7.4 Trigger Port

Use this screen to configure trigger port forwarding on the device. To open this screen, click a
device, click Device Operation in the menu bar and then click Device Configuration >
Advanced > NAT > Trigger Port in the navigation panel.
Figure 90 Device Operation > Device Configuration > Advanced > NAT > Trigger Port
The following table describes the labels in this screen.
Table 80 Device Operation > Device Configuration > Advanced > NAT > Trigger Port
LABEL
WAN
Interface
#
Name
Incoming
Vantage CNM User's Guide
DESCRIPTION
This is the end Inside Local IP Address (ILA). If your rule is for all local IP
addresses, then enter 0.0.0.0 as the Local Start IP address and
255.255.255.255 as the Local End IP address.
This field is N/A for One-to-One and Server mapping types.
This is the starting Inside Global IP Address (IGA). Enter 0.0.0.0 here if you have
a dynamic IP address from your ISP.
This is the ending Inside Global IP Address (IGA). This field is N/A for One-to-
One, Many-to-One and Server mapping types.
Click Apply to save your changes back to the device.
Click Cancel to return to the previous screen.
DESCRIPTION
Select a WAN port to use the port triggering rule.
This is the number of an individual entry.
This field displays a unique name (up to 15 characters) for identification purposes.
Incoming is a port (or a range of ports) that a server on the WAN uses when it sends
out a particular service. The device forwards the traffic with this port (or range of ports)
to the client computer on the LAN that requested the service.
Chapter 7 Device Advanced Settings
191