Figure 43 Device Operation > Device Configuration > Network > Wan > Setup (Prestige) - ZyXEL Communications Centralized Network Management Vantage CNM User Manual

Chapter 5 Device Network Settings
Figure 43 Device Operation > Device Configuration > Network > WAN > Setup (Prestige)
The following table describes the fields in this screen.
Table 27 Device Operation > Device Configuration > Network > WAN > Setup (Prestige)
LABEL
Name
Mode
Encapsulation
Multiplex
Virtual Circuit ID
VPI
VCI
92
DESCRIPTION
Enter the name of your Internet Service Provider, for example, MyISP.
This information is for identification purposes only.
Select Routing from the drop-down list box if your ISP allows multiple
computers to share an Internet account. Otherwise select Bridge.
Select the method of encapsulation used by your ISP from the drop-down
list box. Choices vary depending on the mode you select in the Mode
field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET
ENCAP or PPPoE.
Select the method of multiplexing used by your ISP from the drop-down
list. Choices are VC or LLC.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a
virtual circuit. Refer to the appendix for more information.
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local
management of ATM traffic). Enter the VCI assigned to you.
Vantage CNM User's Guide