Effects In Audio Interface Mode; Insert Effect; Send Return Effect (Reverb) - Zoom R16 Operation Manual

Effects in audio interface mode

The R16's insert and send return effects can both be used when the sampling wavelength is
set to 44.1 kHz. Basic operation is the same but there are a few differences in the menus.

Insert effect

As in recorder mode, select the insert location
and the insert effect algorithm, as well as the
effect patches to be applied to the recording
signal.
Insert effect menu
Select the insert location
You can set it for any INPUT from 1~8.
N o . 0 0 : S t a n d a r d
> I N P U T S O U R C E
(Reference : OPERATION MANUAL P.49)
Apply the effect only to monitoring
If you set "REC SIGNAL" to "Dry," the effect will only be
applied to the monitoring signal and will not affect signals
recorded in DAW software.
N o . 0 0 : S t a n d a r d
> R E C S I G N A L
(Reference : OPERATION MANUAL P.55)
27

Send return effect (reverb)

When in audio interface mode reverb can only
be used for monitoring. As in recorder mode,
you can use the [SEND RETURN EFFECT] menu
to change the patch and the [PAN/EQ] menu to
set the send level that adjusts the depth of the
reverb signal.
Send return effect menu
REVERB SEND
By altering the send level of the REVERB you can adjust
the depth of the added signal.
S E N D R E V E R B
N o . 0 0 : T i g h t H a l
In audio interface mode the [SEND RETURN
EFFECT] key opens the "SEND REVERB" menu,
which is different from the recorder mode.
(Reference: Printed Manual P.35~45)
(Reference: Audio Interface Manual P.25)
NOTE
· Effects can only be used when the sampling rate
is 44.1 kHz. At all other times it is turned OFF.
· Insert and send return effect settings are saved
when you terminate audio interface mode and
can be used again the next time by choosing
[CONTINUE] when you relaunch audio interface
mode.