Installing The Switcher Image Import/Export Software To A Windows Computer - Datavideo HS-1300 Instruction Manual

3.2 Installing the Switcher Image Import/Export software to a Windows
Computer
The HS-1300 can be connected to a simple IP network and accessed using Windows-based software. If you
have not already set up the HS-1300 with a computer then please follow the instructions in the previous
section.
Please download the latest software from the Datavideo HS-1300 web page. See:
www.datavideo.com
The install executable file [.msi] will be called SwitcherImageImEx_vXXXX.msi
The vXXXX represents the latest version number.
Double click this .msi file then follow the on screen install wizard prompts.
Once installed launch the Switcher Image Import/Export software.
The Switcher Image Import/Export software has a built-in IP finder, which is designed for PC with multiple
Ethernet cards or DHCP network environment. Please note IP finder can only find devices that are on the
same network domain as the PC. If you cannot remember your device IP, please press the RESET button to
restore the default network settings. Upon launch of the Switcher Image Import/Export software, you will
be prompted to select one Ethernet Interface Card.
Once selected, click OK to start the scanning process.
Note: Please make sure the selected interface card is on the same network domain as the HS-1300
device.
Once the HS-1300 device is found, the software will connect with the switcher hardware over the IP set up
described in the previous section. If the connection is successfully established, on the software user
interface as shown in the diagram below, the Connect Status will show "Connected" (will display Not
Connected if disconnected).
20