To Install a SCSI Hard Drive
1. Unclip the latch on the right side of the handle.
2. Lower the handle to the fully extended, horizontal position.
3. Grasp the handle with one hand. Support the drive from underneath with the
Figure 21: Drive Partially Inserted
4. Begin to slide the drive into the bay.
5. Gently slide the drive the rest of the way into the bay.
6. When the drive stops moving easily, raise the handle of the drive.
other.
This action engages a lever that pulls the drive the rest of the way into the bay.
Removing and Installing a SCSI Hard Drive (IDP 600 and 1100 Only)
Chapter 8: Servicing the Device
41