To Install A Power Supply; Figure 16: Power Supply Partially Removed - Juniper IDP 600 Series Installer's Manual

Figure 16: Power Supply Partially Removed

6. With the red lever pushed to the right, pull firmly on the extended handle until
7. Let go of the red handle and use both hands to slide the power supply or blank

To Install a Power Supply

You must have a power supply bay available before you can install a power supply.
1. Take the new power supply to the back of the device.
2. Extend the curved handle so you have a good place to grab.
3. Hold the power supply in both hands. With one hand hold the extended handle.
4. Line the power supply up with the empty bay. The red handle should be in the
5. Slide the power supply into the bay.
6. Push firmly until you see and hear the latch (the red lever) snap into place. Both
7. Connect a power cord to the new power supply.
8. Attach the other end of the power cord to the plug strip.
the power supply or blank begins to slide out.
the rest of the way out.
With the other hand, hold the power supply from underneath.
upper left corner above the power plug port.
power supplies should now be even with each other.
If the other power supply is on and powering the device, the device emits a
high-pitched whine and the PS FAIL light on the front of the IDP Sensor lights
up.
Removing and Installing a Power Supply (IDP 200, 600, and 1100 Only)
Chapter 8: Servicing the Device
37