IDP 50, 200, 600, 1100 Installer's Guide
Re-Imaging the IDP Sensor
34
Re-Imaging the IDP Sensor
8. When you have finished upgrading all the Sensors in the cluster, reconnect the
HA cable.
The IDP Sensor comes with software pre-loaded. However, if something happens to
the device, the Sensor software may have to be re-loaded. This process is known as
"imaging."
To re-image the IDP Sensor:
1. Connect a PC to the Console port of the device using the null-modem serial
cable provided with the IDP Sensor.
2. Insert the Sensor CD that came with the Sensor into the CD-ROM drive at the
back of the device.
3. Power cycle the IDP Sensor.
The Sensor boots from the CD and runs the re-imaging process automatically.
4. When the process is complete, configure the IDP Sensor according to the
instructions in Chapter 5, Configuring the IDP Sensor.