Connecting Power; Figure 13: 2U Device Mid-Mount Bracket; Figure 14: 1U Device (Idp 50) Mid-Mount Bracket - Juniper IDP 600 Series Installer's Manual

IDP 50, 200, 600, 1100 Installer's Guide

Connecting Power

NOTE:
18
Connecting Power

Figure 13: 2U Device Mid-Mount Bracket

Figure 14: 1U Device (IDP 50) Mid-Mount Bracket

2. Place the chassis into position between rack posts in the equipment rack and
align the rack mounting bracket holes with the rack post holes.
Be sure to leave at least 2 inches of clearance on the sides of each
CAUTION:
chassis for the cooling air inlet and exhaust ports and access to the network
interface modules.
3. Attach the rack mounting brackets on each chassis to the rack with the
appropriate rack screws.
4. (2U devices only) Attach the other two mid-mount brackets to the chassis and
the back of the rack to hold the device securely in place.
Power is provided to the IDP Sensor via 110/240 VAC from your facility.
1. Connect the provided power cable to the receptacle on the power supply at the
rear of each chassis.
2. Connect the other end of the power cable to the electrical outlet.