Fiber Traffic Port Leds (Idp 600F And 1100F Only); Hard Drive, Cd-Rom Drive, And Power Supply Leds (Back Panel); Table 8: Fiber Traffic Port Led Definitions; Table 9: Hard Drive, Cd-Rom Drive, And Power Supply Led Definitions - Juniper IDP 600 Series Installer's Manual

IDP 50, 200, 600, 1100 Installer's Guide

Hard Drive, CD-ROM Drive, and Power Supply LEDs (Back Panel)

10
LED Definitions

Fiber Traffic Port LEDs (IDP 600F and 1100F only)

Fiber traffic ports have two indicator LEDs: LINK and TX/RX. Fiber traffic ports are
Gigabit Ethernet ports.

Table 8: Fiber Traffic Port LED Definitions

Fiber Traffic Port LED
LINK
TX/RX
The back panel of the Sensors provides access to hard disk drives (600 and1100
Sensors only), CD-ROM drives, and power supplies.

Table 9: Hard Drive, CD-ROM Drive, and Power Supply LED Definitions

Back Panel LED
CD-ROM activity
Hard Drive Failure (600 and 1100 only) The left light on the hard drive. Off if the
Hard Drive Activity
(600 and 1100 only)
Power Supply Status
(200, 600, and 1100 only)
Description
Port connection indicator. Glows green
when the port has a connection.
Port activity indicator. Flashes green
when the port is active.
Description
On the CD-ROM drive. Flashes green to
indicate CD-ROM activity.
hard drive is functioning normally. Glows
red if the hard drive has failed. In
addition, the system emits a high-pitch
noise if a hard drive has failed.
The light flashes red if the drive is being
rebuilt. Do not turn the power off, unplug
the unit, or remove either drive while the
drive is being rebuilt.
The right light on the hard drive. Flashes
green to indicate hard drive activity.
On the power supply above the plug
socket. Glows amber to indicate that the
power supply is receiving power. Glows
green to indicate that the power supply is
powering the unit.
If a power supply has failed, or is not
receiving power, the system will emit a
high-pitched whine.