Installing And Running The User Interface; Installing The Ui; Installing On A Windows Host; Installing On A Red Hat Linux Host - Juniper IDP 600 Series Installer's Manual

Chapter 6
Installing and Running the User
Interface
NOTE:

Installing the UI

Installing on a Windows Host

Installing on a Red Hat Linux Host

This chapter describes how to install and run the IDP User Interface software.
Installing the UI
Running the UI on page 32
Use the IDP User Interface (UI) software to manage your IDP system. You can install
the UI on multiple Windows and Red Hat Linux client machines. Installers for both
Windows and Linux systems are on the CD.
You must install the UI on a system with at least 512 MB of RAM. The UI does not
run on systems with less than 512 MB of RAM.
You can install the Windows UI on a computer running Windows 2000, NT, or XP.
1. Ensure that you are an Administrator user for the computer on which you are
installing the UI. For instructions on adding users to the Administrator group,
see your OS manual.
2. Insert the IDP Installation CD into the CD drive of the computer. If Autoplay is
enabled, the installation starts automatically. If not, run the install application
install.exe from your CD-ROM drive.
3. Follow the directions in the Install wizard to install the UI.
You can install the UI on a computer running Red Hat Linux 8 or RHEL 3 AS, ES,
WS.
1. Insert the IDP Installation CD into the CD drive of the computer and mount the
CD following the manufacturer's instruction.
31
Installing the UI