Connecting To The Idp Sensor; Connecting Directly; Connecting Remotely - Juniper IDP 600 Series Installer's Manual

Connecting to the IDP Sensor

See Connecting Management Ports on page 19 for information on setting up your
Sensor MGT port.

Connecting Directly

1. Connect a standalone computer, such as a laptop, to the Management port on
2. On the standalone computer, open a Web browser.
3. Create a secure connection (https) to the IP address of the Sensor. If you did not
NOTE: Because the ACM uses an SSL connection, you must enter https:// before the IP
address.
4. Enter the default user name (root) and password (abc123).

Connecting Remotely

1. Use the Management port you configured in on page 15 to connect to the IDP
2. On the connected computer, open a Web browser. Enter the URL of the ACM
NOTE: Because the ACM uses an SSL connection, you must enter https:// before the IP
address.
3. Enter the default user name (root) and password (abc123).
the IDP Sensor. To connect directly to the Sensor, use a crossover cable. To
connect to the Sensor over a hub or switch, use a straight-through cable.
change the IP address of the Sensor in Installing the Sensor on page 15, the
default IP address is 192.168.1.1.
When the ACM wizard appears, proceed to Configuring the IDP Sensor with
ACM on page 26.
Sensor from a computer on your network.
To connect directly to another computer, use a cross-over cable. To connect to a
hub or switch, use a straight-through cable.
wizard using the IP address you configured. For example, if you configured the
IP address 10.100.200.1 on the IDP Sensor, enter https://10.100.200.1.
When the ACM wizard appears, proceed to "Configuring the IDP Sensor with
ACM" on page 26.
Chapter 4: Configuring the IDP Sensor
Connecting to the IDP Sensor
25