Figure 12: Rail With Hinged Rear Bracket - Juniper IDP 600 Series Installer's Manual

Figure 12: Rail with Hinged Rear Bracket

2. Rotate the hinges on both rails so that they allow the device to slide into the
rack.
3. Slide the chassis into a set of rails.
Be sure to leave at least 2 inches of clearance on the sides of each
CAUTION:
chassis for the cooling air inlet and exhaust ports and access to the network
interface modules.
4. Secure the front brackets to the rack.
5. Rotate the rear brackets so they prevent the device from sliding forward.
6. Secure the rear brackets to the rack.
To rack mount the Sensor using the mid-mount brackets:
1. Using a flathead screwdriver, attach one rack mounting bracket to each side of
the chassis with the bracket screws.
Chapter 3: Installing the Sensor
Rack Mounting the IDP Sensor
17