Table of Contents
Advertisement
Chapter 7
Updating Software on the Sensor
Updating IDP Sensor Software
NOTE:
This chapter describes how to update the software on an IDP Sensor.
Updating IDP Sensor Software
Re-Imaging the IDP Sensor on page 34
New versions of the IDP Sensor software may be made available online or via
CD-ROM.
You must upgrade the Sensor software on each IDP Sensor in your network before
upgrading the Management Server software.
To install the new software:
1. Verify that you have SSH enabled for the Management Port (eth0).
To enable SSH, select Modify SSH Access from the ACM home page and follow
the prompts.
Access ACM by pointing a web browser at
2. Download the Sensor software from www.juniper.net/support and copy the file
to the
directory of the Sensor.
/tmp
3. Unplug the HA port cable, if one is attached.
4. Log into the IDP Sensor as root via the Console port.
5. Change directory to the
6. Type
sh sensor_<version>.sh
The Sensor update script runs.
Reboot the device when the script is finished.
7. Type
and press
reboot;reboot
https://<sensorIPaddress>
directory.
/tmp
and press Enter.
.
Enter
.
Updating IDP Sensor Software
33
Advertisement
Table of Contents
