Connection Test - Delta DVP-ES3 Series Operation Manual

D V P - E S 3 S e r i e s O p e r a t i o n Ma n u a l
(4) After you successfully download the hardware configuration to the CPU module, the BUS FAULT LED
indicator on the CPU module is OFF. Close the HWCONFIG window. If the BUS FAULT LED indicator
on the CPU module is still ON or blinking, the CPU module is in an abnormal state. Make sure the
actual hardware configuration is the same as the hardware configuration in the HWCONFIG window,
and refer to the operation manual for more information about eliminating the error. Refer to Chapter 8
for more information about HWCONFIG.

Downloading the program
After the program compiles, on the PLC menu point to Transfer, and then click Download. You can also
click
Program checkbox and the Comments checkbox so that you can upload the program in the CPU module
later, and then click OK.
_6

6.6.3 Connection Test

After you download a program to a PLC, you can monitor the execution status of the PLC through ISPSoft.
ISPSoft provides two monitoring modes; device monitoring mode and program monitoring mode.
Monitoring mode
Device monitoring mode
Program monitoring mode
*. You can enable the device monitoring function without program monitoring; however, if you enable the program
monitoring function, the device monitoring function is also enabled.
6 - 2 8
on the toolbar after the program compiles. In the Transfer Setup dialog box select the
You can monitor the status of the devices in the PLC through the monitoring
table. In this mode, ISPSoft updates only the status of the devices. The
current program in ISPSoft does not have to be the same as the program in
the PLC.
In this mode, the operating status of the program is displayed in the program
editing window. The present program in ISPSoft must be the same as the
program in the PLC.
Description