Communications Data Capture; Rs-485 Connection Information; Modbus Connection Information - Delta E Series Software Instructions

伺服壓床簡易配方設定軟體操作說明
4.

Communications Data Capture

4.1

RS-485 connection information

The RS-485 station number can be set through [Euipment Parameters]->[COMM.], please refer to the
table below for other information
Baud rate
9600
4.2

Modbus connection information

The servo press can retrieve the following data in real time via Modbus TCP (default IP: 192.168.1.5 Port:
502)
Status
Pressing result
* Real-time status: 0-not activated; 1-activating; 2-activation complete and waiting; 3-pressing; 4-pressing OK;
5-NG, force is greater than the maximum limit; 6-NG, force is less than the minimum limit; 7-NG, position is
greater than the maximum limit; 8-NG, position is less than the minimum limit
** If you use Modbus communications, please confirm the correctness of the address, and it is strictly forbidden
to write in the relevant address
Date Length
7
Item
Recipe number
Real-time position
Real-time force
Status*
Pressing position
Pressing result
pressing force
Standby time
Pressing time
Production time
Total Amount
Pass Amount
Fail Amount
Parity Stop Bit
E
Modbus
0x13BF
0x10C8
0x10CA
0x10CE
0x10D2
0x1107
0x10D4
0x10D6
0x10D8
0x10DA
0x10DE
0x10E0
0x10E2
23
Mode
1 RTU
Delta PLC
D959
D200
D202
D206
D210
D263
D212
D214
D216
D218
D222
D224
D226