Step 7: Test An Actuator - Delta RMC150 Startup Manual

RMC150 Startup Guide

Step 7: Test an Actuator

You will now test an actuator such as a hydraulic valve or a motor. You
will use the Direct Output command to send a voltage to the actuator.
The actuator must already have been wired to the RMC.
USE THE DIRECT OUTPUT COMMAND WITH CAUTION! IT
DISABLES THE SAFETY FEATURES OF THE RMC!
Fault Controller Button
If the motion causes problems, be prepared to quickly stop the axis by
clicking the Fault Controller button on the toolbar, or pressing Ctrl + K
on the keyboard.
1. Check the machine and make sure that the axis may safely move
in both directions.
2. In the Project tree, double-click
Axis Tools.
14 Delta Computer Systems, Inc.