Step 8: Perform Initial Software Configuration; Enter Configuration Mode; Configure User Accounts And Passwords - Juniper MX2020 Quick Start Manual

MX2020 3D Universal Edge Router Quick Start

Step 8: Perform Initial Software Configuration

Enter Configuration Mode

Configure User Accounts and Passwords

64
This procedure connects the router to the network but does not enable it to forward
traffic. For complete information about configuring the router to forward traffic, including
examples, see the Junos OS configuration guides.
Check the LEDs on the craft interface to verify the hardware status after reinstalling or
powering on the MX2020 router.
For a list of system status verification commands, see the MX2020 3D Universal Edge
Router Hardware Guide at
To configure the software:
Enter Configuration Mode on page 64
Configure User Accounts and Passwords on page 64
Configure System Attributes on page 65
Commit the Configuration on page 66
Verify that the network device is powered on.
1.
Log in as the root user. There is no password.
2.
Amnesiac <ttyd0>
login: root
Start the CLI.
3.
root@% cli
root>
Enter configuration mode.
4.
root> configure
Entering configuration mode.
[edit]
root#
For information about using an encrypted password or an SSH public key string (DSA or
RSA), see authentication.
Add a password to the root administration user account. Enter a clear-text password.
1.
[edit]
root# set system root-authentication plain-text-password
New password: password
Retype new password: password
Create a management console user account.
2.
[edit]
http://www.juniper.net/techpubs/
.
Copyright © 2015, Juniper Networks, Inc.