Step 5: Connect External Devices And Line Card Cables; Connect To A Network For Out-Of-Band Management; Connect A Management Console; Connect The Line Card Cables - Juniper MX480 Quick Manual

Step 5: Connect External Devices and Line Card Cables

Connect to a Network for Out-of-Band Management

Connect a Management Console

Connect the Line Card Cables

Copyright © 2015, Juniper Networks, Inc.
Figure 8: Connect External Devices and DPC Cables
Connect to a Network for Out-of-Band Management on page 15
Connect a Management Console on page 15
Connect the Line Card Cables on page 15
Turn off the power to the management device.
1.
Plug one end of the RJ-45 Ethernet cable into the appropriate
2.
Routing Engine.
Plug the other end of the cable into the network device.
3.
Turn off the power to the management device.
1.
Plug RJ-45 end of the serial cable into the appropriate
2.
Routing Engine.
Plug the female DB-9 end into the device's serial port.
3.
Have ready a length of the type of cable used by the DPC, MPC, MIC, or PIC. For cable
1.
specifications, see the
MX Series Interface Module Reference
If the cable connector port is covered by a rubber safety plug, remove the plug.
2.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Step 5: Connect External Devices and Line Card Cables
ETHERNET
CONSOLE or
.
port on the
AUX port on the
15