Juniper MX2020 Quick Start Manual page 37

Copyright © 2015, Juniper Networks, Inc.
NOTE: The router transport kit handles can be removed to accommodate
aisle width.
Install the winch mount bracket to the rear rack rails by using the six captive screws,
11.
and tighten the screws (see
Figure 25: Installing Winch Mount Bracket to Rack Rails
Adjust the height of the router by turning the handles clockwise until the router
12.
transport platform is aligned with the surface of the mounting shelf and slightly higher
than the mounting shelf (see
NOTE: Make sure the bubbles within the T-shaped levels are between
the lines, indicating the router is level.
Adjust the four leveling mounts on the router transport platform until all four leveling
13.
mounts rest firmly on the ground (see
Use the Transport Kit to Install the Router in the Rack
Figure 25 on page 37).
Figure 26 on page 38).
Figure 26 on page 38).
37