Juniper MX2020 Quick Start Manual page 34

MX2020 3D Universal Edge Router Quick Start
34
NOTE: The router transport kit is equipped with four T-shaped levels on
top of each of the four router transport mounting brackets. Make sure that
the bubbles within the T-shaped levels are between the lines, indicating
that the chassis is level.
CAUTION: Do not raise the chassis above 1 in. (2.54 cm). This ensures the
router will not tilt during transportation, which can result in injury or
damage to the router.
Turn the four wheels on the router transport kit toward the rear of the chassis.
5.
Grasping the handles on the shipping covers, carefully guide the chassis down the
6.
crate ramp to the rack location.
WARNING: Do not push or pull the router fast during transporting. Doing
so can cause the wheels to turn abruptly and tilt the router over.
Position the router transport platform directly under the router, aligning the router
7.
transport platform with the bottom of the chassis by adjusting the four leveling mounts.
NOTE: The router transport platform height can be adjusted from
0.25 in. (0.6 cm) to a maximum of 4 in. (10.16 cm).
Secure the router transport platform to the router transport mounting plates by using
8.
the four latch locks (see Figure 23 on page 35).
Copyright © 2015, Juniper Networks, Inc.