Siemens SINUMERIK 840D sl Programming Manual page 813

Explanation of the column contents:
Line 0 Coding for the starting point:
Lines 1-n: Entries for contour pieces
Job Planning
Programming Manual, 06/2009, 6FC5398-2BP20-0BA0
Column 0: 10 (units digit): G0 = 0
0
10 (tens position): G70 = 0, G71 = 1, G700 = 2, G710 = 3
1
Column 1: starting point of abscissa
Column 2: starting point of ordinate
Column 3-4: 0
Column 5: line index of last contour piece in the table
Column 0: 10 (units digit): G0 = 0, G1 = 1, G2 = 2, G3 = 3
0
10 (tens position): G70 = 0, G71 = 1, G700 = 2, G710 = 3
1
10 (hundreds digit): G90 = 0, G91 = 1
2
10 (thousands digit): G93 = 0, G94 = 1, G95 = 2, G96 = 3
3
10 (ten thousands digit): G60 = 0, G44 = 1, G641 = 2, G642 = 3
4
10 (hundred thousands digit): G9 = 1
5
Column 1: End point abscissa
Column 2: End point ordinate
Column 3: Center point abscissa for circular interpolation
Column 4: Center point ordinate for circular interpolation
Column 5: Feedrate
User stock removal programs
15.3 Generate coded contour table (CONTDCON)
813