Siemens SINUMERIK 840D sl Programming Manual page 391

6.4 Rotations of the tool orientation (ORIROTA, ORIROTR, ORIROTT, ORIROTC, THETA)
Significance
ORIROTA
ORIROTR
ORIROTT
ORIROTC
THETA
THETA=value
THETA=Θe
THETA=AC(...
)
THETA=AC(...)
Θe
PO[THT]=(...
.)
Example of rotations of orientations
Program code
N10 TRAORI
N20 G1 X0 Y0 Z0 F5000
N30 A3=0 B3=0 C3=1 THETA=0
N40 A3=1 B3=0 C3=0 THETA=90
N50 A3=0 B3=1 C3=0 PO[THT]=(180,90)
N60 A3=0 B3=1 C3=0 THETA=IC(-90)
N70 ORIROTT
N80 A3=1 B3=0 C3=0 THETA=30
Job Planning
Programming Manual, 06/2009, 6FC5398-2BP20-0BA0
Angle of rotation to an absolute direction of rotation.
Angle of rotation relative to the plane between the start and end
orientation.
Angle of rotation as a tangential rotation vector to the change of orientation
Angle of rotation as a tangential rotation vector to the path tangent
Rotation of the orientation vector
Angle of rotation in degrees reached by the end of the block
Angle of rotation with end angle Θ
Non-modal switchover to absolute dimensions
Non-modal switchover to incremental dimensions
End angle of rotational vector both absolute with G90 and relative with
G91 (incremental dimensioning) is active
Polynomial for angle of rotation
of rotation vector
e
Comments
; Activate orientation transformation
; Tool orientation
; In Z direction with angle of rotation 0
; In X direction and rotation about 90 degrees
; Orientation
; In Y direction and rotation about 180
degrees
; Remains constant and rotation to 90 degrees
; Angle of rotation relative to change of
orientation
; Rotation vector in angle 30 degrees to X/Y
plane
Transformations
391