Board Connections - Motorola McIAS 1610 Series System Manual

2.9.2 McTi-MR Board Connections
Up to two McTi-24MR or McTi-30MR boards may be installed in McIAS 1623/IP Slot
2 and/or Slot 3. Telephony connections for each board are provided through an
associated T1 or E1 Transition Board. The McTi-MR board plugs into the McIAS from
the front and its associated transition board plugs into the McIAS from the rear.
Important! If a McTi-MR board is installed in Slot 2, then the corresponding transition
board must be installed in Slot 2 from the rear of the unit; if a McTi-MR board is
installed in Slot 3, then the corresponding transition board must be installed in Slot 3
from the rear of the unit.
2.9.2.1 McTi-24MR Digital Connections via T1 Transition Board
The T1 Transition Board provides connections via a DB15F (female) connector or
RJ-48C connector to the telco from the McIAS. McTi-24MR T1 Transition Board
jumper and connector locations are illustrated below.
24