Table of Contents
Advertisement
Size
Mounting
Power
Maximum current
LED Indicators
Audio Output
SIT Encoding
Telephony Interfaces
Voice ports
T1
E1
Analog
In-Band Signaling
Voice Storage
Backup/Upgrades
Ports
Ethernet LAN
Connections (1610/IP option)
Physical connections
Administration
Trouble notification
Compliances
Environmental
Finish
McIAS 1610 Technical Specification
17" (432mm) wide x 5.25" (140mm) high x 12" (305mm) deep
19" (483mm), 21" (533mm), 23" (584mm), 25" (635mm)
or 26" (660mm)
-42 to -60 vdc (-48 vdc nominal)
2.5 amps
Power, status, logic voltages, major and minor alarms
-3 to -15 dBm
Meets Bellcore and CCITT standards
Digital: North American, F-law DS-1 (T1)
European, A-law PCM/30 (E1)
Analog: 4-wire E&M; Ring-Trip
ISDN (in development): Primary Rate, 23B +D
Up to three telephony interface boards
24 to 72
30 to 90
8 to 24
MFR1 and DTMF
Dependent upon disk capacity
Removable disk media
4 Serial; 1 Parallel
AUI; 10Base2; 10BaseT
Power: Screw terminals
E1/T1 Interface: DB15P (15-pin), male required
Analog Interface: 25-pair telco type connector, male required
Alarms: 25 pair telco type connector, male required
VT100-compatible terminal and DTMF telephone
Major and minor alarm relay contact closures
Meets applicable Bellcore, CCITT, UL/CSA and FCC/DOC
requirements
Temperature:
10E to 40E C operational;
10E to 45E C short term
Humidity:
5% to 95%, non-condensing
Cooling:
Filtered forced air
Brushed aluminum
Table 1-1
3
Advertisement
Chapters
Table of Contents
