System Power Up - Motorola McIAS 1610 Series System Manual

Table of Contents

2.10 System Power Up

With power applied to the backplane, the McIAS 1610 red major alarm LED should

be lit.

Note: Prior to turning on the McIAS 1610 power switch, make certain that a terminal

is connected and power to it is turned on.

McIAS 1610 will take approximately 2 minutes to initialize.

Turn on system power to the McIAS 1610 using the switch located on the

power supply board. The red major alarm LED is lit and will remain lit until the

system has finished initializing. The green power LED should remain lit

continually.

When the power switch is turned on, all of the LEDs on the SBC will come on

briefly. As the system initializes, LEDs on the SBC will either flicker or remain on

steadily. A series of self tests and processes being started up will be displayed

on the terminal during initialization.

When the system has completed initialization, the installer should see the

following:

! McTi board LEDs:

McTi-30: All LEDs are off

McTi-24: Green LED is on

McTi-8L: Activity flashes

! Red major alarm LED is off (if this LED is still lit, see Note below)

! "Login" prompt appears on the terminal

! SBC LEDs: See Section 1.3.1

! Power LED is lit brightly

! All other LEDs are off

Note: If the red major alarm LED is still lit at the end of initialization, this could be

caused by more than 50% of the trunks not connected to the CO.

If there appears to have been a problem with system initialization, push the

RESET switch on the front of the SBC board.

Display the Error Log (McIAS 1610/IP) or Alarm Log (McIAS 1610/68) to see if

any errors occurred during system initialization. Refer to the applicable document

for more information:

McIAS 16xx/IP System Operation Manual (P/N 41318310), Section 3.4

McIAS 16xx/68 EASM Operator's Guide (P/N 51315820), Section 2.4.2.1

Correct errors, if any.

Table of Contents

Table of Contents

Mcias 1610/68 Mcias 1610/ip