Motorola McIAS 1610 Series System Manual page 90

4.2 Dip Switch Settings for McTi-30 Boards
Switch bank SW3 on each McTi-30 board identifies the board on the SCSI bus. To
view the location of SW3, refer to the McTi-30 board drawing. The table below lists
the SW3 dip switch settings.
64444444;44444444;44444444>44444444>44444444>44444444>44444444>44444447
BOARD ADDRESS S))))Q > 5
6444444444>4444444x44444444x44444444x44444444x44444444x44444444x44444444x4444444>
5 SW3-5 5 ON
K)))))))))O)))))))3))))))))3))))))))3))))))))3))))))))3))))))))3))))))) 3)))))))O
5 SW3-6 5 ON
K)))))))))O)))))))3))))))))3))))))))3))))))))3))))))))3))))))))3))))))) 3)))))))O
5 SW3-7 5 ON
9444444444=4444444N44444444N44444444N44444444N44444444N44444444N44444444N44444448
NOTE: Addresses 0, 1, 2, 6 & 7 should not be used by McIAS 1610 McTi boards.
Addresses 0, 1, 2, 4, 5, 6 & 7 should not be used by McIAS 1607 McTi boards.
Addresses 0, 1, 2 and 7 should not be used by McIAS 1623/IP McTi boards.
Switch bank SW3 has four other dip switches (SW3-1, SW3-2, SW3-3 and SW3-4)
that are used for signaling variations based on customer specific protocol. McTi-30
boards have one other switch bank, SW2, which is not used.
6444444447
5 McTi-30 5
McIAS 1607 S))))Q > 5 Board 5
:44444444>44444444;444444447
5 McTi-30 5 McTi-30 5 McTi-30 5
McIAS 1610 S))))Q > 5 in Slot 5 in Slot 5 in Slot 5
5
644444444>44444444>44444444>444444447
5 McTi-30 5 McTi-30 5 McTi-30 5 McTi-30 5
McIAS 1623/IP S))))Q > 5 in Slot 5 in Slot 5 in Slot 5 in Slot 5
5
0 1 2
5 5 5
* OFF ON
* *
* ON OFF *
*
* ON ON
* *
Table 4-2
McTi-30 Board
SCSI Bus Dip Switch Settings
42
4 3 2
5 5 5
4 5 6
5 5 5
3 4 5
5 5 5
OFF * ON * OFF * ON
OFF * ON * ON * OFF
ON OFF * OFF * OFF
*
7
5
6 7
5 5
* OFF 5
* OFF 5
* OFF 5