Part 4 Install Announcements/Messages - Motorola McIAS 1610 Series System Manual

PART 4
INSTALL ANNOUNCEMENTS/MESSAGES
The process of installing announcements/messages from a cartridge to the hard disk
is described in the instructions to follow. Note: If the Disk Utility Main Menu is already
displayed on your screen (from Part 3), proceed to Step 3.
1. Press the reset button located on the SBC board.
Note: The absence of an application and the presence of the disk utility on the hard
disk will automatically display the Disk Utility Main Menu on the System
Administration local terminal during system boot up without the user pressing
any key.
2. To access the disk utility and display the Disk Utility Main Menu, press any key
other than P during system boot up after the following appears on the screen (it
may take a few minutes for this to appear):
The following will appear after pressing any key (other than P):
3. Insert the McIAS 16xx Announcement/Message Assembly Disk 1 into the
removable cartridge drive. Note: Refer to Appendix A for instructions on how to
operate the type of drive installed in your system.
4. Press 1 followed by <CR> from the Disk Utility Main Menu to display the
Cartridge to Hard Disk Utility Installation Menu. The following will appear:
Application will start from hard disk.
Press any key within 5 seconds to enter disk utility.
McIAS 1610 Disk Utility
Main Menu
1 - Install Software from Cartridge to Hard Disk
2 - Run System Diagnostics
3 - Exit to Debug Monitor
Enter Selection:
Page 7