V/S24T1 & V/S30E1 Telephony Connections; V/S24T1 Connections - Motorola McIAS 1610 Series System Manual

2.8.4 V/S24T1 & V/S30E1 Telephony Connections

2.8.4.1 V/S24T1 Connections

One V/S24T1 board can be installed in the McIAS 1607/IP or McIAS 1610/IP in the
slot directly above the SBC. Note: The McIAS 1607/IP and 1610/IP require the
installation of the "2+2 Module" for use with the V/S24T1 board. To connect the
V/S24T1 board installed in the McIAS 1607/IP or 1610/IP to the telco, use J8, the
DB15F (female) connector located on the back of the McIAS.
Up to two V/S24T1 digital telephony interface boards may be installed in the VME
expansion slots of the McIAS 1623/IP. For each V/S24T1 board installed in the McIAS
1623/IP, use one of the following connectors located on the back of the McIAS (Slot
2 or Slot 3) to connect to the telco: either the DB15F (female) connector or the
RJ-48C connector.
A diagram showing these connectors and the channels associated with each connector
are provided in Section 2.8.4.3.
Pin connections for the V/S24T1 are as follows:
1. Transmit (Tip) XMIT1
2. Not used
3. Receive (T1) RCV1
4. Not used
5. Not used
6. Not used
7. Not used
8. Not used
9. Transmit (Ring) XMIT2
10. Not used
11. Receive (R1) RCV2
12. Reserved
13. Reserved
14. Reserved
15. Frame
DB15F Connections
(McIAS 1607/IP, 1610/IP & 1623/IP)
OR
16