7.
Before proceding, check to make sure that all alarm LEDs are off and McTi board
LEDs are in a normal state as follows:
If a McTi-30 board is installed, all LEDs are off.
If a McTi-24 board is installed, the green LED is on.
If a McTi-8L board is installed, Activity LED is flashing.
8.
Test the alarm relays to verify that they are properly connected to the CO. Refer
to the applicable document for more information:
McIAS 16xx/IP System Operation Manual (P/N 41318310), Section 3.4.2
McIAS 16xx/68 EASM Operator's Guide (P/N 51315820), Section 2.4.2.3
IMPORTANT!
Do not press the ABORT button on the SBC. Cognitronics Product Support is available
for assistance if initialization problems are encountered at (203) 830-3560 Monday
through Friday from 8:30 a.m. to 5:00 p.m. ET.
20