Part 2 Install Disk Utility Program - Motorola McIAS 1610 Series System Manual

PART 2
INSTALL DISK UTILITY PROGRAM (Factory Use Only.)
(Proceed to Part 3 if Disk Utility is already installed and functional)
The process of installing the Disk Utility Program from cartridge to the hard disk is
described in the instructions to follow. Once it is installed, the Disk Utility Program
is used to install application and announcement/message software from a cartridge
to the hard disk (described in Parts 3 and 4).
1. Press the reset button located on the SBC board.
2. To invoke the PROM Utility Menu, press P during system boot up after the
following appears on the screen (it may take a few minutes for this to appear):
Note: At system start-up, if McIAS does not find an application program or disk
utility program on the hard disk, the above prompt will not appear and the PROM
Utility Menu will automatically be displayed (without pressing P).
The PROM Utility Menu appears as follows:
WARNING! Selection 2, Initialize Hard Disk, should only be used at the customer
site if the instructions accompanying the new software direct the user
to do so.
Application will start from hard disk.
Press any key within 5 seconds to enter disk utility.
PROM UTILITY MENU
1 - Install disk utility from cartridge to hard disk
2 - Initialize hard disk
3 - Load and run the disk utility
4 - Call 147BUG
Enter:
Page 3