Motorola McIAS 1610 Series System Manual page 113

MODEL 2513 & MODEL 2513EL DRIVE MAINTENANCE INSTRUCTIONS
Introduction
This document contains the procedure for cleaning and maintaining the
MODEL2513 drive. The cleaning period varies depending on usage and
environment. Usually it is necessary to clean the drive once every six months. Refer
to the "Removable Cartridge Guide" and verify which type of drive is used in your
system before attempting to use this procedure.
Materials Required
McIAS16xx/68 system with a MODEL2513 removable drive.
Cleaning kit, Model 2513 Drive, Cognitronics P/N 40331020,
Contains this document and Fujitsu cleaner disk,
(Note: Fujitsu Cleaning Kit for 640MB, M2513A Drive, P/N CA90002-C980)
WARNING! DO NOT USE ANY CLEANING KIT OTHER THAN COGNITRONICS
P/N 40331020 OR FUJITSU P/N CA90002-C980. DAMAGE TO
THE DRIVE LENS AND HEAD MAY OCCUR IF OTHER TYPES OF
MAGNETO-OPTICAL CLEANING PRODUCTS ARE USED !
Procedure
Caution: Check the cleaning brush state by opening the shutter door of
the head cleaner cartridge. If the tips of the bristles are open,
use a new head cleaner cartridge.
Hold the head cleaning cartridge so the shutter points toward the drive and the
label is up so you can read it. Insert the head cleaning cartridge into the
removable cartridge drive. Push the cartridge into the slot until it stops. When
inserted, a label on the drive's door will indicate that a cartridge is in the drive.
Once inserted, the head cleaner will start and finish automatically. The cleaning
operation takes about 10 seconds.
Page A-11