Model 2513 Drive Operation Instructions - Motorola McIAS 1610 Series System Manual

MODEL 2513 Drive Operation Instructions

Note: If there is a
cartridge in the drive,
this will be indicated by
a label on the door
MODEL 2513
*
WARNING! THE EMERGENCY EJECT HOLE SHOULD ONLY BE USED TO EJECT THE
CARTRIDGE WHEN POWER IS TURNED OFF. DAMAGE TO THE DRIVE AND/OR CARTRIDGE
CAN OCCUR IF THE CARTRIDGE IS REMOVED WHILE IT IS STILL SPINNING. READ ALL
INSTRUCTIONS BEFORE ATTEMPTING TO USE THIS FEATURE.
Model 2513
How to Insert a Removable Cartridge into the Drive
1. Hold the cartridge so the shutter points toward the drive and the Cognitronics
label is up so you can read it. Insert the cartridge into the removable cartridge
drive. Push the cartridge into the slot until it stops. When inserted, a label on the
drive's door will indicate that a cartridge is in the drive.
2. While the disk is spinning up, the drive's green LED will flash. After a few
seconds, the LED will go off. During system operation, the LED will only light
when the disk is being accessed.
How to Remove a Cartridge from the Drive
1. Press the normal eject button on the drive.
2. The drive's LED will blink for several seconds after which the cartridge will eject
and the LED will go off.
3. Remove the cartridge, place it in its protective case and store it in a secure
location, away from magnetic fields.
LED States:
Data Transfer = green
Cartridge in or out = Off
*Emergency
Eject Hole
Page A-8
Normal Eject Button