Installation Summary - Motorola McIAS 1610 Series System Manual

2.9 Installation Summary

Below is a summary of the installation process:
1. Mount the McIAS 1610 in the telco rack.
2. Set up and connect a terminal. Refer to Section 2.6 for external connections.
3. Connect a modem and printer, if desired. Refer to Section 2.6 for external
connections.
4 Connect telephony interface board(s) to the telco end via connectors J3, J4, J6,
J7 (analog) or J8, J9, J10 (digital). For digital boards, test internal digital McTi
connections by jumpering together the appropriate pins on either the backplane
connector(s) or on the Digital Connector Block. See Section 2.0 in the McIAS
Telephony Interface Boards and Trunk Connections Manual for more information.
5. Connect alarm relays to the telco end via J5 connector.
6. Connect Ethernet LAN, if applicable.
7. Apply -48 volt system power and -48 volt return (ground) to the screw terminals
located on the lower rear section of the unit. If analog board(s) are installed,
connect signal battery and ground. Refer to Section 2.4 for more information.
Note: When power is applied to the McIAS 1610 backplane, the red major alarm LED
and the green power LED should light brightly. The major alarm LED will remain
lit until the initialization process is complete. If the major alarm LED does not
light when power is applied, check for a blown fuse or reversed wires.
8. Proceed to Section 2.10 for power-up instructions.
18