Motorola McIAS 1610 Series System Manual page 75

McIAS 1623/IP Channel Configuration Example:
As an example, a McIAS 1623/IP with four McTi-24 boards installed and two
McTi-24MR boards installed may have channels distributed as follows:
McTi Board #
1 (McTi-24)
2 (McTi-24)
3 (McTi-24)
4 (McTi-24)
5 (McTi-24MR)
6 (McTi-24MR)
Refer to the McIAS 1623/IP MOP Guide (P/N 51325920), MOP 510 for line
assignment instructions.
Note: It is a good practice to test internal McTi-MR connections (see MOP 308 to
connect loopback). A successful test will result in all McTi-MR board front panel LEDs
turned off with the exception of the "Active" LED which should be blinking.
Important! McTi-MR Board 5 and McTi-MR Board 6 may be installed in McIAS 1623/IP
Slot 2 and Slot 3, respectively; however, if Board 5 is powered OFF then it must be
removed from the unit in order to ensure proper operation of Board 6.
Slot # Channels
4 1-24
5 25-48
6 49-72
7 73-96
2 97-120
3 121-144
Connector
J8
J9
J10
J11
DB15F or RJ-48C (T1 Transition Board)
DB15F or RJ-48C (T1 Transition Board)
27