Preparation; Hardware Configuration; Table 1-1. Mvme5100 On-Board Jumpers And Default Settings - Motorola AltiVec MVME5100 Series Installation & Use Manual

Preparation

Hardware Configuration

To produce the desired board configuration and to ensure proper operation
of the MVME5100, it may be necessary to perform certain modifications
before and after installation. The following paragraphs discuss the
preparation of the MVME5100 hardware components prior to installing
them into a chassis and connecting them.
The MVME5100 provides software control over most of its options by
setting bits in control registers. After installing it in a system, you can
modify its configuration. For additional information on the board's
control registers, refer to the MVME5100 Single Board Computer
Programmer's Reference Guide in
It is important to note that some options are not software-programmable.
These specific options are controlled through manual installation or
removal of jumpers or additional interface modules on the MVME5100.
The following table lists the manually configured jumpers on board the
MVME5100:

Table 1-1. MVME5100 On-Board Jumpers and Default Settings

Jumper Description
J4 Ethernet Port 2 Selection
J6, J20 Operation Mode
(Set Both Jumpers)
J7 Flash Memory Selection
J10, J17 Ethernet Port 2 Selection
J15 System Controller (VME)
J16 Soldered Flash Protection
http://www.motorola.com/computer/literature
Appendix C, Related
Setting
For "P2" Ethernet Port 2:
Pins 1,2; 3,4; 5,6; 7,8
For "Front Panel" Ethernet Port 2:
No Jumpers Installed
Pins 1,2 for PMC Mode
Pins 2,3 for 761 Mode
Pins 1,2 for Soldered Bank A
Pins 2,3 for Socketed Bank B
For "Front Panel" Ethernet Port 2:
Pins 1,3 and 2,4 on Both Jumpers
For "P2" Ethernet Port 2:
Pins 3,5 and 4,6 on Both Jumpers
Pins 1,2 for No SCON
Pins 2,3 for Auto SCON
No Jumper for ALWAYS SCON
Pins 1,2 Enables Programming of Flash
Pins 2,3 Disables Programming of Flash
Preparation
Documentation.
Default
No
Jumper
Installed
PMC
Mode
Socketed
Bank B
Front
Panel
Ethernet
Port 2
Auto
SCON
Flash
Prog.
Enabled
1-3
1