Part 1 System Start-Up - Motorola McIAS 1610 Series System Manual

PART 1
SYSTEM START-UP
Refer to the appropriate McIAS 16xx Series System Manual for detailed system
installation instructions.
1. Turn on system power using the switch located on the Power Supply board. (No
Cognitronics AppSOFT modules are required to be installed at this time.) During
the boot up process McIAS will list the disk drives currently installed in the
system and their addresses on the data highway bus. Also during boot up, a
confidence test is run on the Single Board Computer (SBC).
2. If the confidence test is successful and no failures are found, the application
program that exists on the hard disk (if any) will be executed.
3. If the confidence test fails, the test is aborted when the first fault is encountered
and the FAIL LED on the front panel of the SBC lights and remains lit until the
fault is corrected. In this case, McIAS sets a major alarm which will remain active
until the problem is corrected. If possible, a system message will appear on the
terminal screen indicating where the fault occurred. In this case, contact
Cognitronics Product Support at (203) 830-3560 for assistance.
Page 2