Assigning Component Parameters To Control Changes - Yamaha DME32 Owner's Manual

246
Chapter 15—MIDI
Assigning Component Parameters to Control
Changes
Parameters can be assigned to MIDI Control Changes 0 through 119, and an additional byte
can be used to provide a higher resolution for more precise control of parameters with a
large range. A table for you to note assignments is provided on page 280.
1 Choose MIDI from the Tool menu.
The MIDI window appears.
2 Click the Control Change tab.
The Control Change page appears, as shown below.
Select the Control Change that you want to assign and then click Assign, or simply
3
double-click the Control Change number.
The Control Change window appears, as shown below.
Make the required settings and then click OK to save them, or click Cancel to
4
leave them unchanged.
The Control Change window closes.
If a parameter has already been assigned to the selected Control Change, an overwrite con-
firmation message appears. Click OK to overwrite the previous assignment, or click Cancel
to keep it.
DME32—Owner's Manual