Aligning Components to the Grid
The grid, a pattern of regularly spaced horizontal and vertical dotted lines, is convenient
for aligning components. When the Snap to grid option is on, components automati-
cally align to the grid as they are added or moved. Components already in a configura-
tion can be aligned to the grid by using the Align command.
Note that the grid is only available when zoom is set to 100%.
Choose Grid from the View menu.
1
The Grid window appears, as shown below.
The Grid parameters are explained in the following table.
Section
Parameter
Show grid
Snap to grid
X
1
Spacing
Y
1. Can be specified using the adjacent buttons or entered from the keyboard.
Make the required settings and then click OK to save your settings, or click
2
Cancel to leave them unchanged.
The Grid window closes.
When the grid is on, unaligned components can be aligned by using the Align com-
mand, which appears in the Edit and Shortcut menus and on the Tool Bar.
The following configuration window shows a typical grid with an even X/Y spacing.
Aligning Components to the Grid
Range
Check/
Turns the grid on and off. When on, the grid
uncheck
appears in the configuration window.
Turns snap to grid on and off. When on, compo-
Check/
nents snap to the grid when they are added or
uncheck
moved.
10–99
Sets the horizontal grid spacing
10–99
Sets the vertical grid spacing
Description
DME32—Owner's Manual
49