166
Chapter 9—Component Guide Part II
Filter
There are four components in the Filter group: HPF (high-pass filter), LPF (low-pass
filter), BPF (band-pass filter), and NOTCH (notch filter).
HPF
An HPF (high-pass filter) attenuates signals below the specified frequency while allow-
ing signals above that frequency to pass through unaffected.
The HPF control window features INPUT, filter, and OUTPUT sections.
The HPF component parameters are explained in the following table.
Section
ON/OFF
INPUT
Filter
OUTPUT LEVEL
MUTE
DME32—Owner's Manual
The HPF component features one input and one output.
Parameter
Range
ON/OFF
LEVEL
–Infinity dB to 0.0 dB
PHASE
NOR/REV
FREQ
20.0 Hz–20.0 kHz
–6 dB/octave,
SLOPE
–12 dB/octave
–Infinity dB to 0.0 dB
ON/OFF
Description
Turns the component on and off
Adjusts the input signal level
Inverts the input signal
Adjusts HPF cutoff frequency
Selects the filter slope
Adjusts the output signal level
Mutes the output