Midi Data Format - Yamaha DME32 Owner's Manual

If (MIDI DATA - Z) < 0
If ((MIDI DATA - Z)/X) > MAX
Otherwise
4.2 Program Change (Cn)
Reception
These messages are received if [Program Change RX] is ON and the [Rx CH] matches.
However, if [OMNI] is ON, they are received regardless of the channel.
These messages are echoed if [Program Change ECHO] is ON.
Scene memories are recalled according to the [Program Change Assign Table].
Transmission
If [Program Change TX] is ON, this message is transmitted on the [Tx CH] according
to the settings of the [Program Change Assign Table] when a scene is recalled.
If the scene memory number that was recalled is assigned to more than one Program
Change, the lowest-numbered Program Change is transmitted.
If [Program Change ECHO] is ON, these messages are echoed.
STATUS 1100nnnn Cn
DATA 0nnnnnnn nn
4.3 Parameter Change (byte operation for type 0x00: edit buffer)
Reception
These messages are received if [Parameter Change RX] is ON and the [Rx CH] matches
the Device Channel included in the SUB STATUS of the message.
These messages are echoed if [Parameter Change ECHO] is ON.
When these messages are received, the corresponding parameter is controlled.
Transmission
If [Parameter Change TX] is ON, this message is transmitted on the [Tx CH] Device
Channel when a parameter not specified in the [Control Change Assign Table] is
adjusted.
These messages are transmitted without change if [Parameter Change ECHO] is ON.
STATUS 11110000 F0
ID No. 01000011 43
SUB STATUS 0001nnnn 1n
GROUP ID 00111110 3E
MODEL ID 00000101 05
PARAM TYPE 00000000 00
DATA 0000aaaa dd1
0000bbbb dd2
0000cccc dd3
0000dddd dd4
0000eeee dd5
0000ffff dd6
0000gggg dd7
0000hhhh dd8
EOX 11110111 F7

MIDI Data Format

param = 0
param = MAX
param = INT ((MIDI DATA –Z)/X
Program Change
Program No. (0–127)
System Exclusive Message
Manufacturer's ID No.(YAMAHA)
parameter change or response for request
n=0-15 (Device Channel No.1-16)
group ID (digital mixer)
Device code (DME32)
byte operation for edit buffer
Parameter No. (H high order bit)
Parameter No. (H low order bit)
Parameter No. (L high order bit)
Parameter No. (L low order bit)
Parameter value (H high order bit)
Parameter value (H low order bit)
Parameter value (L high order bit)
Parameter value (L low order bit)
End Of Exclusive
285
DME32—Owner's Manual