Selecting Cable Mode; Adding Wires - Yamaha DME32 Owner's Manual

Selecting Cable Mode

Cable mode is used to wire components together.
To select Cable mode, choose Cable from the Mode menu.
1
Alternatively, choose Cable mode from the Shortcut menu, Tool bar, Tool Palette, or Alt
menu.
"Cable" appears in the status bar and the cursor changes to the cable tool, as shown
below.
In Cable mode, active DME32s, active meaning connected and turned on, display the
message "EDIT CONTROL."
To leave Cable mode, select another mode (e.g., Edit or Run).
2
The status bar indicates the newly selected mode.

Adding Wires

Wires can be added individually or in multiples.
Adding Individual Wires
Select Cable mode.
1
See "Selecting Cable Mode" on page 51.
Position the cable tool over the first node.
2
A small box appears around the node, as shown below.
Drag the wire to the second node, as shown below.
3

Selecting Cable Mode

DME32—Owner's Manual
51