Setting up the Vocal Harmony Control Parameters
You can set which part controls the Vocal Harmony regardless of the current Vocal Harmony Type.
1
Call up the Vocal Harmony Type Selection display.
[MIC SETTING/VOCAL HARMONY] [D]/[E] TYPE SELECT
Check that the microphone is properly connected (Owner's Manual, chapter 8) and the settings (Reference Manual,
NOTE
setting the Vocal Harmony Control parameters here.
2
Press the [8 ] (SETUP) button to call up the Setup display, then set the value by
using the [2 ]–[5 ] and [7 ] buttons.
For information on each parameter, see
3
After you finish setting the value, press the [EXIT] button to close the Setup display.
page
86.
page
82) are adjusted correctly before
PSR-S950/S750 Reference Manual
8
85