Revision 1.0
Coprocessor 0
Coprocessor 0
The RSP coprocessor 0 is thoroughly discussed in Chapter 4, but is
mentioned here for completeness.
Coprocessor 0 in the MIPS R4000 architecture is designated as the "system
control coprocessor". Since the RSP is a slave processor, the system control
functions are greatly reduced, and therefore the usage of coprocessor 0 does
not conform to the MIPS R4000 architecture specification.
does
The RSP
use coprocessor 0 for "system control" functions, these
functions (and their registers) are explained in Chapter 4.
45