Printing Troubles - Fuji Xerox Versant 3100 Press Printer Unit Manual

3.1.1

Printing Troubles

When paper jams or any other troubles with the printer unit occurs, follow the procedures shown in the
touch screen. If the machine does not work properly after taking the procedure, contact your local Fuji
Xerox representative.
Troubles with the Printer Unit
Symptom
Power switch is on, but
printer is not turned on
Refer "1.2
On/Off"
(p.12)
The <Error> indicator is
blinking
The <Error> indicator is lit
The touch screen is too
dark
34
Printer Unit Manual
Cause
Is the emergency main power switch
in the (ON) position?
<|>
Is the circuit breaker switch in the
Power
"ON" (upper position)?
The printer unit or optional units may
be having trouble.
The hard disk may not be recognized.
Is there a paper jam?
Is any cover open?
Is any massage shown, suggesting
the replacement of consumables?
Is any error massage shown?
Is the <Power Saver> button lit?
Remedy
Press the main power switch to the
position.
Press the circuit breaker switch to the "ON"
(upper position).
Switch off the printer and then on again.
Confirm that the power to the High Capacity
Feeder C3-DS and optional unit is on.
Switch off the printer and then on again.
Follow the instruction displayed and remove
jammed papers.
Follow the instructions displayed to solve the
problem.
Follow the instructions displayed to solve the
problem.
Follow the instructions displayed to solve the
problem.
If an error code such as "016-450" is displayed,
check the error code list and solve the problem.
"8.2 Error Messages" in the User
Refer
Interface Manual.
The printer is in the Power Saver mode.
Press the <Power Saver> button on the control
panel to exit the Power Saver mode.
Refer "1.4 Power Saver Mode" in the
User Interface Manual.
| (ON)
< >