Fuji Xerox Versant 3100 Press Printer Unit Manual page 42

1.
Open the left side and center covers of the printer
unit.
2.
Turn lever "2" in the unlocking direction (toward the
opened-lock mark).
3.
Grip lever "2" and gently pull out the Transfer Module
toward you until it stops.
If the paper is curled and caught in the Transfer Module, stop
pulling when the jammed paper is visible, and then continue to
pull it out while holding down the paper with a hand.
4.
Remove jammed papers.

Paper Jams at Area "2a" ...................................................................................................................................................p.42

Paper Jams at Lever "2b" ..................................................................................................................................................p.43

Paper Jams at Area "2c"....................................................................................................................................................p.43

Paper Jams at Lever "2d" / "2e" ......................................................................................................................................p.43

Paper Jams at Lever "2f" ...................................................................................................................................................p.44
Important
Note
Paper Jams at Area "2a"
(1) Remove jammed papers rightward.
Important
Note
42
Printer Unit Manual
Be sure to remove jammed papers in the Areas "2a" and "2c", and then remove the paper at the
Levers "2b" and "2d" / "2e".
Solutions differ depending on where the paper jam occurs. Confirm the jammed area in the Error
Message area.
If you pull out the paper in the opposite way, smudge
will remain inside.
If you cannot see any jammed paper, check lever

"2b" and area "2c" as well.
If there are sheets in both lever "2b" and area "2c",

remove the paper in area "2c" first.