Main Power Switch; Circuit Breaker Switch - Fuji Xerox Versant 3100 Press Printer Unit Manual

1.2.3

Main Power Switch

If you turn off the main power, the power consumption can be
reduced. (but cannot be reduced to zero.)
Note that the machine needs more time to warm up if switched on
after the main power is off.
The printer may be damaged if you switch the main power off
immediately after switching the power off. Make sure the <Power
Saver> button is out and then switch off the main power.
Cooling down may take up to 60 minutes.
Switching off the main power may damage the hard disk and the memory or cause a printer malfunction,
please adhere to the following guidelines.
Important
Do not switch the main power off while the touch screen displays a screen or the <Power Saver> button

blinks.
Switch the main power off first when unplugging the power cord.

Do not switch off the main power immediately after switching on the main power.

Open Machine Center Door and push the lower side of the switch to <O> (OFF).
The <Power> indicator goes out on the control panel.
The switch is normally in the upper <|> (On) position.
1.2.4

Circuit Breaker Switch

The switch is normally in the upper position.
If the machine will be moved or unused for an extended period of time, turn off the switch by pressing it
to the lower position.
Note When fault current is detected, the circuit breaker is automatically turned off to discontinue the electrical
flow. Do not touch the breakers under normal condition. For information on fault current, refer to the Safety
Notes.
Printer Unit
High Capacity Feeder C3-DS
14
Printer Unit Manual
Breaker switch
TEST button
Breaker switch
TEST button